Golf Mk5
Assembly overview - catalytic converters and attachments, engine codes BLN, BLP, BLF |
1 - | Warm air collector plate |
2 - | 10 Nm |
3 - | Exhaust manifold |
4 - | Gasket |
q | Renew. |
5 - | 25 Nm |
q | Renew. |
6 - | 40 Nm |
q | Renew. |
7 - | Washer |
8 - | Bracket |
9 - | 60 Nm |
10 - | 25 Nm |
11 - | Mounting |
12 - | Connector |
Only engine codes BLN, BLP |
Note
Engines with engine code BLF are not fitted with an exhaust gas temperature sender 1 -G235-. |
q | Black, 2-pin. |
q | For exhaust gas temperature sender 1 -G235-. |
13 - | Exhaust gas temperature sender 1 -G235-, 45 Nm |
Note
Engines with engine code BLF are not fitted with an exhaust gas temperature sender 1 -G235-. |
14 - | 23 Nm |
15 - | Double clamp |
16 - | To front silencer |
17 - | Catalytic converter with exhaust pipe |
18 - | NOx sender control unit -J583- |
Note
For engines with engine code BLF a Lambda probe after catalytic converter -G130- is installed. 4-pin connector. |
q | Location: on underbody. |
q | The Lambda probe after catalytic converter is a component of the NOx sender -G295-. |
q | Removing and installing NOx sender -G295- using Lambda probe ring spanner set -3337- |
q | Specified torque: 50 Nm |
q | Grease only the threads with „G 052 112 A3“; „G 052 112 A3“ must not get into the slots on the probe body. |
q | If seal is leaking, nip open and renew. |
19 - | Securing nut |
20 - | 25 Nm |
21 - | Connector |
q | Black, 6-pin. |
q | For Lambda probe -G39- and Lambda probe heating -Z19-. |
22 - | Lambda probe -G39-, 50 Nm |
q | Grease only the threads with „G 052 112 A3“; „G 052 112 A3“ must not get into the slots on the probe body. |
q | Remove and install with Lambda probe open ring spanner set -3337-. |
23 - | 40 Nm |
24 - | Bracket |
25 - | Starter catalytic converter with exhaust pipe |
26 - | Cable guide |
q | For alternator cable. |
27 - | Bellows |