Golf Mk5
Note
|
| 1 - | Securing bolt |
| q | Removing and installing crankshaft pulley → Chapter. |
| q | Renew. |
| q | Contact surface for securing bolt must be free of oil and grease. |
| q | Secure pulley against turning with counterhold 3415. |
| q | The turning further angle can be measured with a commercial protractor. |
| 2 - | Belt pulley |
| q | With diamond coated washer |
| q | Contact surfaces must be free of oil and grease. |
| q | Secure against turning with counterhold 3415 when removing and installing. |
| q | Removing and installing poly V-belt (engine codes BLG, BMY) → Chapter. |
| q | Removing and installing poly V-belt (engine code BWK) → Chapter. |
| 3 - | Seal |
| q | Removing and installing → Chapter. |
| 4 - | Bearing bush |
| q | Contact surfaces must be free of oil and grease. |
| 5 - | O-ring |
| q | Renew. |
| 6 - | Cylinder block |
| q | Removing and installing → Chapter. |
| 7 - | 60 Nm + 1/4 turn (90°) further |
| 8 - | Flywheel/drive plate |
| q | When removing and installing flywheel, lock with counterhold -T10044-. |
| 9 - | Intermediate plate |
| q | Must seat on dowel sleeves. |
| q | Do not damage or bend when assembling. |
| 10 - | 12 Nm |
| q | Renew. |
| 11 - | Sealing flange with sender wheel and oil seal |
| q | Removing and installing engine speed sender -G28- (not shown) → Chapter. |
| q | Specified torque for engine speed sender -G28-: 5 Nm. |
| q | Renew sealing flange complete with oil seal and sender wheel only. |
| q | Removing and installing crankshaft sealing flange on flywheel end → Chapter |
