volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing anti-theft engine control unitJ623 (Golf model year 2004 ? 2008) > < Engine control unitJ623

Golf Mk5

Removing and installing engine control unitJ623 (Golf model year 2004 ► 2008)
Removing and installing engine control unit -J623- (Golf model year 2004 ► 2008)
If you wish to renew the engine control unit, connect the → Vehicle diagnostic testerVehicle diagnostic, testing and information system and carry out the guided function „Renew control unit“.
Removing
–  Switch off ignition.
–  Remove wiper arms and plenum chamber cover: → Electrical system; Rep. gr.92.
–  Remove plenum chamber bulkhead → General body repairs; Rep. gr.50.
   
–  Remove securing bolts -1- and remove cover plate -2-.
  N24-10055
–  Release front connector -1- from engine control unit and pull it off.
–  Lever up catch -2- slightly.
–  Then press engine control unit out of retainer -in direction of arrow-.
–  Then release rear connector on engine control unit and pull it off.
Installing
–  Fit rear connector to engine control unit and lock in position.
–  Push engine control unit onto bracket.
–  Fit front connector to engine control unit and lock it in position.
–  Install cover plate for connectors.
  N24-10056
–  Tighten securing bolts -1- to 10 Nm.
–  Install plenum chamber bulkhead → General body repairs; Rep. gr.50.
–  Install wiper arms and plenum chamber cover: → Electrical system; Rep. gr.92.
–  If engine control unit is renewed, clear learnt values and adapt engine control unit → Vehicle diagnostic tester„Guided functions“.
–  Read fault memory, repair faults if necessary and then clear fault memory → Vehicle diagnostic tester„Guided fault finding“.
–  The readiness code must be generated if the fault memory has been erased.
–  Carry out a road test.
–  Read control unit fault memory again.
  N24-10055

Removing and installing anti-theft engine control unitJ623 (Golf model year 2004 ? 2008) > < Engine control unitJ623