volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing drive plate > < Removing and installing metal sealing flange

Golf Mk5

Removing and installing flywheel
Removing and installing flywheel
Special tools and workshop equipment required
   
t  Counterhold tool -3067-
Removing
l  Gearbox removed
–  Remove clutch pressure plate → Rep. Gr.30.
–  Mark position of flywheel relative to engine.
  W00-0026
–  Insert counterhold tool -3067- to unscrew bolts.
–  Unbolt flywheel.
Installing
Installation is carried out in the reverse order. When installing, note the following:
Flywheel can only be installed in one position, holes are offset.
–  Use new bolts for securing.
–  Fit counterhold tool -3067- the other way round to tighten bolts.
–  Install clutch pressure plate → Rep. Gr.30.
Specified torque
  A13-0637
ComponentNm
Flywheel to crankshaft60 Nm + turn 90° further

   

Removing and installing drive plate > < Removing and installing metal sealing flange