volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Crankshaft > < Removing and installing flywheel

Golf Mk5

Removing and installing drive plate
Removing and installing drive plate
Special tools and workshop equipment required
   
t  Counterhold -T10069-
  W00-1059
t  Torque wrench -V.A.G 1332-
t  Depth gauge
t  Straight edge
  W00-0428
Removing
–  Remove drive plate. To do this, counterhold vibration damper using counterhold -T10069-.
–  Loosen drive plate securing bolts diagonally and remove.
–  Remove drive plate.
  N13-0559
Installing
–  Fit drive plate on crankshaft.
–  Insert at least 3 old securing bolts and tighten to 30 Nm.
–  Check dimension -a- through the three holes for securing the torque converter using a straightedge and depth gauge and calculate average.
–  Compare average with specification (measured distance + thickness of straight edge). Specification: 15.7…16.5 mm
If specification is not attained:
  V13-1282
–  Remove drive plate again and fit appropriate shim -1-.
  Note
Only one shim of the appropriate thickness may be used for compensation.
When specification is attained:
–  Insert new securing bolts and tighten by hand.
–  Tighten securing bolt to 60 Nm + 90° (1/4 turn) further.
  V13-1281

Crankshaft > < Removing and installing flywheel