Golf Mk5
Overview of battery, transmitter/receiver unit, fuse and wiring harness |
1 - | Positive connection |
q | Red wire with appropriate connection |
2 - | To terminal 15a |
q | Connection to terminal 15a: → Current flow diagrams, Electrical fault finding and Fitting locations |
q | Ensure that this wire is protected by a fuse. |
q | Fuse maximum 15 A |
3 - | Aerial earth |
q | Ensure good earth connection to body. |
q | Treat fitting location of aerial with appropriate corrosion protection. |
4 - | Transmitter/receiver aerial |
q | Fitting locations ⇒ Table → Chapter |
5 - | Screened aerial wire |
q | Cable with coaxial connector |
6 - | Transmitter/receiver unit, telephone or two-way radio unit |
7 - | Wiring harness |
q | Positive voltage supply via a red wire with 2.5 mm2 cross section. |
q | Negative voltage supply via a brown wire with 2.5 mm2 cross section. |
q | If necessary, black wire with 1.5 mm2 cross section to terminal 15a. |
8 - | Fuse holder |
q | Install in immediate vicinity of battery. |
9 - | To starter |
10 - | Battery |
q | Fitting location in engine compartment |
11 - | Negative wire |
12 - | Body earth |