volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Lights and switches in engine compartment > < Interior lights and switches

Golf Mk5

Removing and installing interior monitoring deactivation switchE267 and deactivation button for vehicle inclination senderE360
Removing and installing interior monitoring deactivation switch -E267- and deactivation button for vehicle inclination sender -E360-
Special tools and workshop equipment required
   
t  Removal wedge -VAS 3409-
  Note
t  The anti-theft alarm system must be deactivated before the interior monitoring deactivation switch -E267- and the deactivation button for vehicle inclination sender -E360- can be removed → Chapter.
t  When removing and installing components that are in view (switches, covers, trim and so on), mask off areas in which tools (removal wedge -VAS 3409-, screwdriver) are used to lever out those components using commercially available tape.
t  The interior monitoring deactivation switch -E267- and the deactivation button for vehicle inclination sender -E360- are located in the B-pillar trim on the driver side.
Removing:
–  Switch off ignition and all electrical consumers and remove ignition key.
  W00-0016
–  Carefully prise out the interior monitoring deactivation switch -E267- and the deactivation button for vehicle inclination sender -E360- using the wedge -VAS 3409- or a suitable screwdriver.
  N96-0398
–  Release connector -arrow- and pull off.
Installing:
Installation is carried out in reverse order of removal.
  N96-0399

Lights and switches in engine compartment > < Interior lights and switches