volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing key-operated switch to deactivate front passenger side airbagE224 > < Removing and installing hazard warning light switchE3

Golf Mk5

Removing and installing left footwell lightW9 and right footwell lightW10
Removing and installing left footwell light -W9- and right footwell light -W10-
Special tools and workshop equipment required
   
t  Removal wedge -VAS 3409-
  Note
t  When removing and installing components that are in view (switches, covers, trim and so on), mask off areas in which tools (removal wedge -VAS 3409-, screwdriver) are used to lever out those components using commercially available tape.
t  Removal and installation of both footwell lights is performed in the same way and is described as follows for just one light.
Removing:
–  Switch off ignition and all electrical consumers.
  W00-0016
–  Use removal wedge -VAS 3409- or screwdriver to prise footwell light out of trim beneath dash panel.
  N96-10151
–  Disconnect connector -arrow-.
Renewing bulb:
  N96-10150
–  Release locking lugs -1- and remove heat shield -2- from light lens.
  N96-0396
–  Carefully lever bulb out of holder.
–  Renew glass-base bulb (12 V, 5 W).
Installing:
Installation is carried out in reverse order of removal.
  N96-0347

Removing and installing key-operated switch to deactivate front passenger side airbagE224 > < Removing and installing hazard warning light switchE3