–
| Lift up locking tabs -arrows- on coil connector -1- slightly and pull coil connector backwards off steering column and steering column switch. |
Installation is carried out in the reverse order. When installing observe the following: |
Caution The turn signal switch reset lever can break when coil connector is being installed. |
The turn signal lever must be in the 0 position when the coil connector is being installed so that the reset lever is not extended. |
|
Note During installation of coil connector, coil connector must be in central position and road wheels must be in „straight-ahead“ position. |
The central position (depending on manufacturer) of the coil connector is shown in the following diagram: |
|
|
|