–
| Set battery to respective operating mode with INFO. |
In the display, the symbol -1- for „Service charge for wet batteries“ or symbol -2- for „Service charge for gel/absorbent glass mat batteries“ will appear. |
–
| Set battery capacity (Ah) of battery for charging using respective button „Up“↑ or „Down“↓. |
–
| Connect red terminal clamp „+“ to positive terminal on battery. |
Note In vehicles with start/stop function and battery monitor control unit -J367- fitted, black terminal clamp must be connected to body earth. Connecting it to battery negative terminal will cause start/stop system to malfunction. |
–
| Connect black terminal clamp „-“ to negative terminal. |
–
| Press START / STOP for approx. 5 seconds. The menu „charging totally discharged batteries/support mode“ will be activated. |
–
| Press respective button „Up“↑ or „Down“↓ to set respective battery voltage (6 V, 12 V or 24 V). |
Note If a button is not pressed within 5 seconds the charger will return to the main menu (select operating mode). |
–
| Confirm the selected battery voltage with START / STOP. |
Then follows the enquiry for "is charger cable terminal polarity correct". |
–
| Check polarity of charger unit cables. |
–
| Confirm polarity of charger unit cables with START / STOP. |
Charger will start charging sequence for totally discharged battery. |
Ending battery charging sequence: |
–
| Disconnect black terminal clamp „-“ of charger from negative terminal. |
–
| Disconnect red terminal clamp „+“ of charger from positive terminal on battery. |
–
| Pull charger plug out of battery charger. |
|
|
|