Golf Mk6
Assembly overview - door hinges |
Note
t | The right side is shown. The left side is similar. |
t | The hinge bolts must always be renewed if loosened. |
t | Hinges are one piece. |
t | If a hinge is replaced, it must be greased. |
1 - | Door |
q | Removing and installing → Chapter |
q | Adjusting → Chapter |
2 - | Guide bolt |
q | Specified torque: 10 Nm |
3 - | Door hinge with arrester |
q | Greasing when hinge is replaced → Chapter |
4 - | Multi-point socket head bolt |
q | Specified torque: 38 Nm |
q | Always renew bolts after loosening. |
5 - | Cover |
6 - | Multi-point socket head bolt |
q | Installed from inside vehicle. |
q | Remove lower A-pillar trim → General body repairs, interior; Rep. gr.70. |
q | Specified torque: 50 Nm |
q | Always renew bolts after loosening. |
7 - | Multi-point socket head bolt |
q | Specified torque: 38 Nm |
q | Always renew bolts after loosening. |
8 - | Cover |
9 - | Multi-point socket head bolt |
q | Specified torque: 50 Nm |
q | Always renew bolts after loosening. |
10 - | Bottom spacer plate |
11 - | Adjuster ring |
q | Restricts the adjustment range for the eccentric pin. |
12 - | Bolt |
q | For eccentric pin |
q | Specified torque: 28 Nm |
13 - | Door hinge |
q | Door hinge is one piece. |
q | Greasing when hinge is replaced → Chapter |
14 - | Multi-point socket head bolt |
q | Specified torque: 50 Nm |
q | Always renew bolts after loosening. |
15 - | Multi-point socket head bolt |
q | Specified torque: 50 Nm |
q | Always renew bolts after loosening. |
16 - | Cover |
17 - | Multi-point socket head bolt |
q | Specified torque: 38 Nm |
q | Always renew bolts after loosening. |
18 - | Eccentric pin |
q | The eccentric pin serves to adjust the shut line. |
19 - | Top spacer plate |
20 - | Guide bolt |
q | Specified torque: 10 Nm |