Golf Mk6
1 - | ABS speed sensor |
q | Before inserting sensor, clean hole inner surface and coat with high-temperature paste G 052 112 A3. |
2 - | Hexagon socket head bolt, 8 Nm |
3 - | Multi-point socket head bolt, 90 Nm and turn 90° further |
q | Always renew after removing. |
4 - | Wheel bearing housing |
5 - | Splash plate |
6 - | Torx bolt, 12 Nm |
7 - | Wheel hub with wheel bearing |
8 - | Brake disc |
q | Ø 253 mm |
q | Thickness: 10 mm |
q | Wear limit: 8 mm. |
q | When worn, renew on both sides of axle. |
q | Unscrew brake caliper prior to removing. |
9 - | Cross-head screw, 4 Nm |
10 - | Bolt |
11 - | Brake pads |
q | Thickness: 11 mm not including backplate. |
q | Wear limit: 2 mm not including backplate. |
q | Checking thickness: Maintenance Booklet → Booklet. |
q | Always replace on both sides |
q | Removing and installing → Chapter. |
12 - | Brake carrier with guide pin(s) and protective cap |
q | Supplied as genuine part, assembled with sufficient grease on guide pins. |
q | If protective caps or guide pins are damaged, install repair kit. Use lubricant sachet supplied to lubricate guide pins. |
13 - | Brake caliper |
q | Do not disconnect brake hose when changing pads. |
q | Removing and installing → Chapter. |
q | Repairing → Chapter. |
q | Adjust handbrake cable first after repairing or renewing. |
q | Adjusting handbrake → Chapter. |
14 - | Hose retainer |
15 - | Brake line, 14 Nm |
16 - | Self-locking hexagon bolt, 35 Nm |
q | Renew. |
17 - | Handbrake cable |
q | Both locking lugs must be engaged on brake caliper bracket. |
q | Adjusting handbrake → Chapter. |
18 - | Brake hose |