volkswagen Workshop Repair Guides

Volkswagen Golf Workshop Service and Auto Repair Manuals

ABOUT US
Preparing installation of multi-clutch > < Installing clutch cover (end cover)

Removing and installing clutch for 6-speed DSG gearbox in Golf Mk6

Removing clutch
Removing clutch
To remove the clutch, proceed as follows:
–  Secure gearbox to an assembly stand in vertical position.
–  Remove clutch cover → Chapter.
   
–  Remove retaining ring from clutch cover.
–  Remove cover from clutch.
  N30-10090
–  Remove retaining ring -arrow-.
  Caution
Carefully remove clutch. Ensure that end cover or other parts of clutch do not fall out. Therefore, do not turn over clutch under any circumstances!
Thread in plate carrier by hand → Anchor.
  N30-10095
–  Remove clutch.
  N30-10089
–  Remove pump shaft -A-.
–  Put pump shaft to one side until inserting it after new clutch is installed.
  N30-10088

Preparing installation of multi-clutch > < Installing clutch cover (end cover)