volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Selector mechanism up to 02.2009 > < Emergency release of selector lever

Golf Mk6

Removing and installing knob
Removing and installing knob
It is possible with all knobs that lock button is pressed into knob. Do not install a knob with the locking button pressed in.
   
–  Before removal, pull lock button out past its pressure point.
–  Secure lock button with a cable tie or wire against being pressed in.
–  Unclip cover.
  N34-11399
–  Push sleeve upwards to release knob.
  N34-11379
The locking button must not be pressed in.
  N34-10549
–  However, should this happen, unclip knob trim upwards.
–  Press small lever for pull rod -arrow- back into groove before installing knob.
–  Lock knob again after installing. Press sleeve under knob back down.
  N34-10551
–  If the knob is »new«, just remove the transport guard. The locking button is already in installation position.
–  Pull connector from cover.
–  Pull off knob upwards.
–  Lock knob again after installing. Press sleeve under knob back down.
  N37-10434

Selector mechanism up to 02.2009 > < Emergency release of selector lever