Volkswagen Workshop Service and Repair Manuals

Renewing seal on gearbox selector lever Special tools and workshop equipment required

t  Tube -VW 423-

t  Puller hooks -T20143-

t  Torque wrench -V.A.G 1331- –  Remove selector lever cable from gearbox → Chapter.

–  Carefully pry lever -A- off selector shaft.

–  Lever out seal. –  Lightly oil outer circumference of new oil seal. –  Half-fill space between sealing lip and dust lip with sealing grease -G 052 128-.

–  Drive in new seal to stop, being careful not to cant seal. –  Set lever in place and tighten to 20 Nm. Selector shaft lever fits on splines in only one position –  Install and adjust selector lever cable on gearbox → Chapter.