Volkswagen Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Installing >
< Removing and installing over-centre spring, Golf 2009 ? right-hand drive
Golf Mk6
Power transmission
6-speed manual gearbox 02Q
Clutch, control / Repairing clutch mechanism, Golf, Golf Plus and Scirocco / moving_and_installing_over-centre_spring_golf_2009_?_right-hand_drive/">Removing and installing over-centre spring, Golf 2009 ? right-hand drive
Removing
Removing
Removing
–
First check whether a coded radio is fitted. If so, obtain anti-theft code.
–
With ignition switched off, disconnect battery earth strap
→ Electrical system; Rep. gr.27
.
–
Push driver seat as far back as possible and put steering wheel in highest position.
–
Remove trim and cover below trim on driver side
→ Rep. gr.68
.
–
Remove knee airbag bracket.
→ Interior equipment; Rep. gr.69
–
Remove footwell vent
-3-
.
→ Heating, air conditioning; Rep. gr.80
–
Remove cable guide
-2-
from steering column.
–
Remove crash bar
-1-
(bolt
-2-
).
If fitted, remove damping
-arrow-
from lower area of clutch pedal mounting bracket.
–
To do this, remove lock washers
-A-
for damping.
–
Pull off damping.
–
Push damping upwards in area of upper securing nut
-1-
above clutch pedal
-A-
in
-direction of arrow-
.
–
Unbolt clutch pedal
-1-
from mounting bracket
-3-
by removing nut
-2-
and pulling out bolt
-5-
.
Note
The clutch pedal remains hooked to operating rod of master cylinder.
–
Swing clutch pedal down slightly and remove over-centre spring
-4-
from mounting bracket.
Power transmission
6-speed manual gearbox 02Q
Clutch, control / Repairing clutch mechanism, Golf, Golf Plus and Scirocco / moving_and_installing_over-centre_spring_golf_2009_?_right-hand_drive/">Removing and installing over-centre spring, Golf 2009 ? right-hand drive
Removing
Installing >
< Removing and installing over-centre spring, Golf 2009 ? right-hand drive