–
| Then turn gear lever guide in -direction of arrow 1-. |
l
| Pin -arrow 2- must be in notch in selector housing |
–
| Then swing out gear lever guide with gear lever in -direction of arrow 3-. |
Caution The lower end of the compression spring (-arrow 1- ⇒ figure above) can snap off the shoulder of the gate selector lever out of control during the further procedure. |
|
–
| Therefore, carefully press it down off shoulder of gate selector lever. |
The ends of the compression spring then become tensioned „diagonally“ with a loud noise. |
–
| Slacken ends -A- and -B- by turning both round to right. |
|
|
|