Golf Mk6
| Dismantling and assembling output shaft 1 - overview |
| 1 - | Output shaft 1 |
| 2 - | Needle bearing |
| 3 - | Synchromeshed gear for 2nd gear |
| 4 - | Synchro-ring |
| 5 - | Outer ring |
| 6 - | Synchro-ring |
| 7 - | Locking collar and synchro-hub for 2nd and 4th gears |
| q | Dismantling and assembling → Chapter |
| 8 - | Synchro-ring |
| 9 - | Outer ring |
| 10 - | Synchro-ring |
| 11 - | Needle bearing |
| 12 - | Sleeve for needle bearing |
| 13 - | Synchromeshed gear for 4th gear |
| 14 - | Washer |
Note| Output shaft is assembled as far as this washer for purpose of adjusting shaft. |
| 15 - | Needle bearing |
| 16 - | Sleeve for needle bearing |
| 17 - | Synchromeshed gear for 3rd gear |
| 18 - | Synchro-ring |
| 19 - | Outer ring |
| 20 - | Synchro-ring |
| 21 - | Locking collar and synchro-hub for 1st and 3rd gears |
| q | Dismantling and assembling → Chapter |
| 22 - | Synchro-ring |
| 23 - | Outer ring |
| 24 - | Synchro-ring |
| 25 - | Needle bearing |
| 26 - | Sleeve for needle bearing |
| 27 - | Synchromeshed gear for 1st gear |
| 28 - | Thrust washer |
| 29 - | Bearing |
Note| Always renew the bearings on a shaft together. |
| 30 - | Bolt |
| q | Removing → Chapter |
| q | Installing and torque setting → Chapter |
| – | Always renew. |
| 31 - | Ball socket |
| q | Removing and installing → Chapter>>>>>>>> |
| l | Bearing races are not allowed to be swapped over. They are paired with the bearing. |
| 32 - | Ball socket |
| q | Removing and installing → Chapter>>>>>>>> |
| l | Bearing races are not allowed to be swapped over. They are paired with the bearing. |
| 33 - | Bearing |
| q | Pressing off → Anchor |
| q | Pressing on → Anchor |
Note| Always renew the bearings on a shaft together. |
