–
| Remove oil pressure switch -F1- -brown insulation- using 24 mm hinged wrench -T40175- and screw into tester. |
–
| Screw tester into oil filter bracket in place of oil pressure switch. |
–
| Connect brown wire of tester to earth (-). |
–
| Connect voltage tester -V.A.G 1527B- to battery positive (+) and oil pressure switch using auxiliary cables from -V.A.G 1594 A-. LED must not light up. |
–
| Start engine and increase speed slowly. At 0.55…0.85 bar the LED must light up, otherwise renew oil pressure switch. |
|
|
|