Golf Mk6
| Assembly overview - cylinder block, gearbox end |
| 1 - | Bolt |
| q | Renew. |
| q | 60 Nm + 90° |
| 2 - | Dual-mass flywheel |
| q | Removing and installing → Chapter. |
| q | Assembly through offset holes only possible in one position |
| 3 - | Sender wheel |
| q | For engine speed sender -G28-. |
| 4 - | Engine speed sender -G28- |
| q | Removing and installing → Chapter. |
| 5 - | 5 Nm |
| 6 - | Dowel pin |
| q | Qty. 2. |
| 7 - | Intermediate plate |
| q | Do not damage or bend when assembling → Fig.. |
| 8 - | Sealing flange on flywheel end |
| q | with shaft seal |
| q | Renewing → Chapter. |
| 9 - | Bolt |
| q | Specified torque and tightening sequence → Fig.. |
|
|
|
|
| Stage | Bolts | Specified torque |
| 1. | -1 … 6- | Screw in to contact by hand |
| 2. | -1 … 6- | in diagonal sequence and in stages; final torque 15 Nm |
