Volkswagen Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Mounting assembly toolT10134 with sealing flange on crankshaft flange >
< Pressing sealing flange with sender wheel onto crankshaft
Golf Mk6
Power unit
4-cylinder injection engine (1.2 l direct injection engine, turbocharger)
Enginecrankshaft group, pistons
Cylinder block, gearbox end / moving_and_installing_crankshaft_sealing_flange_on_gearbox_side/">Removing and installing crankshaft sealing flange on gearbox side
Mounting seal with sender wheel on assembly toolT10134
Mounting seal with sender wheel on assembly toolT10134
Mounting seal with sender wheel on assembly tool -T10134-
–
Screw in hexagon nut
-B-
to just before clamping surface
-A-
of threaded spindle.
–
Clamp assembly device -T10134- in a vice on clamping surface
-A-
of threaded spindle.
–
Press assembly housing
-C-
downwards until it lies on hexagon nut
-B-
.
–
Screw hexagon nut onto threaded spindle until inner part of assembly device and assembly housing are at same height.
–
Remove securing clip
-arrow-
from new sealing flange.
Note
The sender wheel must not be taken out of the sealing flange or twisted.
–
Locating hole
-A-
on sender wheel
-C-
must align with marking
-B-
on sealing flange.
–
Place sealing flange with front side downwards on a clean flat surface.
–
Push sealing lip support ring
-A-
downwards in direction of arrow until it lies on flat surface.
–
Upper edge of sender wheel and front edge of sealing flange must align
-arrows-
.
–
Place sealing flange with front side on assembly tool -T10134- so that locating pin
-A-
can be inserted in sender wheel hole
-A-
.
Note
Ensure sealing flange lies flat on assembly tool.
–
Press sealing flange and sealing lip support ring
-B-
against surface of assembly tool -T10134- whilst tightening 3 knurled screws
-A-
.
This prevents locating pin from slipping out of sender wheel hole.
Note
When installing sealing flange, ensure that sender wheel remains fixed in assembly device.
Power unit
4-cylinder injection engine (1.2 l direct injection engine, turbocharger)
Enginecrankshaft group, pistons
Cylinder block, gearbox end / moving_and_installing_crankshaft_sealing_flange_on_gearbox_side/">Removing and installing crankshaft sealing flange on gearbox side
Mounting seal with sender wheel on assembly toolT10134
Mounting assembly toolT10134 with sealing flange on crankshaft flange >
< Pressing sealing flange with sender wheel onto crankshaft