Golf Mk6
Part II |
1 - | 10 Nm |
q | Apply locking fluid when fitting. |
2 - | Centre toothed belt guard |
3 - | Engine bracket |
4 - | 45 Nm |
5 - | Upper toothed belt guard |
q | Removing and installing → Chapter. |
6 - | 23 Nm |
7 - | Washer |
8 - | Semi-automatic belt tensioner |
q | Checking → Chapter. |
9 - | 100 Nm |
q | Use counterhold tool -3415- to loosen and tighten. |
10 - | Camshaft toothed belt pulley |
q | Locked in installation position by Woodruff key → Item. |
11 - | 10 Nm |
q | Insert with locking fluid. |
12 - | 23 Nm |
q | Insert with locking fluid. |
13 - | Rear toothed belt guard |
14 - | Woodruff key |
q | Check for secure seating. |
15 - | O-ring |
q | Renew |
16 - | Coolant pump |
q | Removing and installing → Chapter. |
17 - | 15 Nm |
18 - | Crankshaft toothed belt pulley |
q | Contact surface between toothed belt pulley and crankshaft must be free from oil. |
q | Can only be installed in one position |
19 - | 90 Nm + turn 90° further |
q | Renew. |
q | Do not oil. |
q | Use counterhold tool -3415- to loosen and tighten. |
20 - | Toothed belt |
q | Mark direction of rotation with chalk or felt pen before removing. |
q | Check for wear. |
q | Removing and installing → Chapter. |
21 - | Lower toothed belt guard |
22 - | 10 Nm |
q | Insert with locking fluid. |