Volkswagen Workshop Service and Repair Manuals

Removing and installing fuel delivery unit Special tools and workshop equipment required

t  Wrench -T10202-

t  Torque wrench (40…200 Nm) -V.A.G 1332- Removing l  Fuel tank should be no more than 3/4 full.   Note t  After removing fuel delivery unit, check fuel tank for heavy soiling and clean if necessary. t  If necessary, empty fuel tank using fuel extractor -VAS 5190- → Chapter. t  Note safety precautions before beginning work → Chapter. t  Observe rules for cleanliness → Chapter. –  Remove rear seat bench (Golf Plus: rear right seat) → General body repairs, interior; Rep. Gr.72.

–  Remove covers from fuel pump unit.

–  First check that the connector -arrow- is fitted securely by pulling the connector without pressing the catch. The connector can cause a fault if it has not been fitted correctly. –  Now pull off connector. –  Check the contacts on the connector and on the fuel delivery unit for damage.   WARNING Fuel supply line is pressurised. Wear eye protection and protective clothing to avoid possible injury and skin contact. Before loosening hose connections, wrap a cloth around the connection. Then release pressure by carefully pulling hose off connection.

–  Pull fuel lines -1- and -2- off flange.   Note t  Press in securing ring to release fuel lines. t  On vehicles with auxiliary heater the connector and the fuel line of the metering pump -V54- must also be separated.

–  Open locking ring using wrench -T10202- and raise flange slightly. –  Pull fuel delivery unit and seal out of the opening in fuel tank.   Note t  If delivery unit is to be renewed, drain old delivery unit before disposal. t  Observe waste disposal regulations. Installing: –  Renew seal. –  Insert seal for fuel delivery unit dry into opening of fuel tank. –  Coat inner side of seal with fuel. –  When inserting fuel delivery unit, ensure that fuel gauge sender is not bent.

–  Press sealing flange down against spring pressure, and move sealing flange to installation position. l  Tab -2- on sealing flange must be between lugs -1- and -3- on fuel tank. l  The -arrow- points forwards. –  Tighten sealing flange. l  Specified torque: 110 Nm.

–  Reconnect supply line-1- (black). –  Reconnect fuel return line -2- (blue or blue marking).

–  Reconnect connector -arrow-. –  Ensure push-fit couplings and electrical connectors are secured properly by pulling. Further installation is performed in the reverse sequence. In the process, note the following: t  Observe installation position of fuel feed line to auxiliary heater → Auxiliary heater; Rep. Gr.82. t  Always ensure wiring connections are secured properly by pulling back.

t  Arrow on cover points in direction of normal travel -2-.