volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing thermostat > < Removing and installing toothed belt for coolant pump

Golf Mk6

Renewing oil seal for coolant pump drive
Renewing oil seal for coolant pump drive
Special tools and workshop equipment required
   
t  Thrust piece -T10353-
Procedure
Proceed as follows:
–  Remove toothed belt for coolant pump → Chapter.
  W00-10472
–  Press screwdriver -1- firmly onto section -2- of oil seal -arrow B-.
–  Lever out oil seal -arrow A-.
–  Clean contact surface and sealing surface.
  A19-10462
–  Lubricate sealing surface of balance shaft -2- with gear oil.
–  Fit oil seal -1- onto balance shaft.
l  The marking „Air side“ („Outside“) -arrow- should be legible from the outside.
  A19-10463
–  Apply thrust piece -T10353- to oil seal -1- and press into cylinder block as far as stop using bolt -2- (take care not to tilt oil seal).
–  Fit toothed belt for coolant pump → Chapter.
Further assembly is performed in the reverse order of removal.
  A19-10464

Removing and installing thermostat > < Removing and installing toothed belt for coolant pump