volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing shock absorber for adaptive chassis control DCC (four-wheel drive) > < Assembly overview: shock absorber for adaptive chassis control DCC (four-wheel drive)

Golf Mk6

Removing and installing rear body acceleration senderG343 (four-wheel drive)
Removing and installing rear body acceleration sender -G343- (four-wheel drive)
Special tools and workshop equipment required
   
t  Torque wrench -V.A.G 1410-
Removing
–  Remove wheel.
–  Remove wheel housing liner (rear left) → Rep. gr.66.
  W00-0554
–  Release connector and pull off.
–  Unscrew bolts and remove rear body acceleration sender -G343-.
Installing
Install in reverse order. Note the following points:
  Caution
The rear body acceleration sender must never be swapped over with the front body acceleration senders, assignment in → Electronic parts catalogue „ETKA“.
  N43-10036
–  Note installation position of rear body acceleration sender -G343- on the bracket.
Lug of bracket -1- must engage in recess in front right body acceleration sender -G342--arrow-
  N43-10037
Specified torques
ComponentSpecified torque
Rear body acceleration sender -G343- to bracket5 Nm

   

Removing and installing shock absorber for adaptive chassis control DCC (four-wheel drive) > < Assembly overview: shock absorber for adaptive chassis control DCC (four-wheel drive)