Volkswagen Workshop Service and Repair Manuals > Golf Mk6 > Vehicle electrics | Electrical system | Lights, lamps, switches inside, anti-theft system | Interior lights and switches | Interior monitoring deactivation switchE267 and deactivation button for vehicle inclination senderE360 | Removing and installing interior monitoring deactivation switchE267 and deactivation button for vehicle inclination senderE360

Removing and installing interior monitoring deactivation switchE267 and deactivation button for vehicle inclination senderE360

Removing and installing interior monitoring deactivation switch -E267- and deactivation button for vehicle inclination sender -E360-

Special tools and workshop equipment required

t	Removal wedge -VAS 3409-

Note

t	The interior monitoring deactivation switch -E267- and the deactivation button for vehicle inclination sender -E360- form one component.

t	The anti-theft alarm system must be deactivated before the interior monitoring deactivation switch -E267- and the deactivation button for vehicle inclination sender -E360- can be removed → Chapter.

t	When removing and installing components that are in view (switches, covers, trim and so on), mask off areas in which tools (removal wedge -VAS 3409-, screwdriver) are used to lever out those components using commercially available tape.

t	The interior monitoring deactivation switch -E267- and the deactivation button for vehicle inclination sender -E360- are located in the B-pillar trim on the driver side.

Removing:

–	Switch off ignition and all electrical consumers and remove ignition key.

–	Carefully lever out the interior monitoring deactivation switch -E267- and the deactivation button for vehicle inclination sender -E360--1- using the wedge -VAS 3409- or a suitable screwdriver.

–	Release connector -arrow- and pull off.

Installing:

Installation is carried out in reverse order of removal.