Removing and installing lock cylinder |
Caution t
| When batteries are disconnected and reconnected, the procedure described in the workshop manual must be strictly observed → Chapter. |
t
| The steering lock could be destroyed. |
t
| If the steering lock is actuated without lock cylinder, it will block and must be renewed. |
t
| The steering lock must not be actuated without lock cylinder. |
|
Note t
| For reasons of clarity, the illustration is shown without steering column switch, coil connector or steering wheel. There is no need to remove the components in order to remove the lock cylinder. |
t
| The immobilizer reading coil is secured to the lock cylinder and cannot be renewed individually. |
t
| For reasons of clarity, the ignition key is not shown in the following illustrations. |
t
| The hole may be 180° further than shown in the illustration. This does however not affect the procedure for removing and installing. |
|
|
|