Volkswagen Workshop Service and Repair Manuals > Golf Mk6 > Vehicle electrics | Electrical system | Lights, lamps, switches outside | Park assist steering | Park assist steering control unitJ791 | Removing and installing (left-hand drive models) park assist steering control unitJ791

Removing and installing (left-hand drive models) park assist steering control unitJ791

Removing and installing (left-hand drive models) park assist steering control unit -J791-

The park assist steering control unit -J791- is located in the driver footwell, above the relay carrier.

Removing:

–	Switch off ignition and all electrical consumers and remove ignition key.

–	Remove footwell trim on driver side → General body repairs, interior; Rep. gr.68.

–	Remove securing screw -arrow- for park assist steering control unit above relay carrier.

–	Remove windscreen wiper system → Chapter.

–	Remove the three securing nuts -arrows- and remove cover -1-.

–	Release and disconnect the three connectors -arrows- and remove the park assist steering control unit -J791--1- upwards out of bracket.

Installing:

Install in the reverse order of removal. When doing this, note the following:

–	Tighten securing bolt of park assist steering control unit -J791- to 1.5 Nm.

Volkswagen Workshop Service and Repair Manuals