Volkswagen Workshop Service and Repair Manuals > Golf Mk6 > Vehicle electrics | Electrical system | Starter-current supply-CC | Starter, vehicles with dual clutch gearbox (DSG) | Starter, vehicles with 1.8 l, 118 kW TSI engine and dual clutch gearbox (DSG) DQ200-7F | Removing and installing starter, 1.8 l, 118 kW TSI engine, dual clutch gearbox (DSG) DQ200-7F

Removing and installing starter, 1.8 l, 118 kW TSI engine, dual clutch gearbox (DSG) DQ200-7F

Special tools and workshop equipment required

t	Torque wrench -V.A.G 1331-

t	Torque wrench -V.A.G 1332-

Removing:

–	Disconnect battery → Chapter.

–	Remove air filter housing → Power unit; Rep. gr.24.

–	Release and disconnect connector -1-.

–	Slide protective cap -1- off solenoid switch in direction of -arrow-.

–	Unscrew securing nut -1- and remove positive wire -2- from connector thread of solenoid switch.

–	Remove upper securing bolt of starter -arrow-.

–	Remove lower securing bolt of starter -arrow-.

–	Remove starter from vehicle.

Installing:

Install in the reverse order of removal. When doing this, note the following:

–	Tighten threaded connections to torques specified in assembly overview → Chapter.