Volkswagen Workshop Service and Repair Manuals

Removing and installing starter, 1.4 l, 90 kW TSI engine, manual gearbox MQ 200-6F Special tools and workshop equipment required

t  Torque wrench -V.A.G 1331-

t  Torque wrench -V.A.G 1332- Removing: –  Disconnect battery → Chapter. –  Remove air filter housing → Engine mixture preparation; Rep. gr.24.

–  Release and disconnect connector -1-.

–  Slide protective cap -1- off solenoid switch in direction of -arrow-.

–  Unscrew securing nut -1- and remove positive wire -2- from connector thread of solenoid switch.

–  Unscrew nut -1- from upper securing bolt of starter and remove earth cable -2-. –  Unscrew upper securing bolt of starter that is located behind. –  Remove noise insulation → General body repairs, exterior; Rep. gr.50.

–  Unscrew nut -1- and remove cable holder -2- from bottom securing bolt of starter.

–  Unscrew lower securing bolt -2- off starter. –  Remove starter -1- downwards from vehicle. Installing: Install in the reverse order of removal. When doing this, note the following: –  Tighten threaded connections to torques specified in assembly overview → Chapter.