volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Starter, vehicles with 2.5 l, 125 kW injection engine and manual gearbox MQ250-5F > < Assembly overview

Golf Mk6

Removing and installing starter, vehicles with 1.8 l, 118 kW TSI engine and manual gearbox MQ200-6F
Removing and installing starter, vehicles with 1.8 l, 118 kW TSI engine and manual gearbox MQ200-6F
Special tools and workshop equipment required
   
t  Torque wrench -V.A.G 1331-
  W00-0427
t  Torque wrench -V.A.G 1332-
Removing:
–  Disconnect battery → Chapter.
–  Remove air filter housing → Engine mixture preparation; Rep. gr.24.
  W00-0428
–  Slide protective cap in direction of -arrow- off solenoid switch.
  N27-10117
–  Unscrew positive wire -1- and disconnect connector from terminal 50 -2-.
  N27-10118
–  Unscrew securing nut -arrow- and remove earth cable from the upper securing bolt on starter.
  N27-10010
–  Remove upper securing bolt of starter -arrow-.
–  Remove noise insulation → General body repairs, exterior; Rep. gr.50.
  N27-10011
–  Remove nut -1- from lower securing bolt of starter.
–  Remove wiring retainer -2-.
  N27-10012
–  Remove lower securing bolt of starter -arrow-.
–  Remove starter.
Installing:
Install in the reverse order of removal. When doing this, note the following:
–  Tighten threaded connections to torques specified in assembly overview → Chapter.
  N27-10013

Starter, vehicles with 2.5 l, 125 kW injection engine and manual gearbox MQ250-5F > < Assembly overview