Volkswagen Workshop Service and Repair Manuals

Removing and installing starter, 2.0 l, 125 kW TDI engine, manual gearbox MQ350-6F Special tools and workshop equipment required

t  Spring-type clip pliers -VAS 5024A-

t  Torque wrench -V.A.G 1331-

t  Torque wrench -V.A.G 1332- Removing: –  Disconnect battery → Chapter. –  Remove the air filter housing → Engine mixture preparation; Rep. gr.23.

–  Slide protective cap in direction of -arrow- off solenoid switch.

–  Unscrew positive wire -1- and disconnect connector from terminal 50 -2-.

–  Remove securing bolt of starter -arrow-. –  Remove noise insulation → General body repairs, exterior; Rep. gr.50.

–  Remove securing nut -1- from lower securing bolt of starter. –  Remove wiring retainer -2-.

–  Remove lower securing bolt of starter -arrow-. –  Remove starter from vehicle. Installing: Install in the reverse order of removal. When doing this, note the following: –  Tighten threaded connections to torques specified in assembly overview → Chapter.