volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Adjusting headlight washer system spray jets > < Removing and installing spray jet pop-up cylinders »Golf R«

Golf Mk6

Removing and installing spray jet assembly
Removing and installing spray jet assembly
  Note
t  Following illustrations show removal and installation of left spray jet assembly.
t  Removal and installation of right spray jet assembly are carried out in the same way.
Removing:
–  Switch off ignition and all electrical consumers and remove ignition key.
   
–  Pull spray jet with cover cap -1- to stop out of bumper cover.
–  Unclip cover cap -1- from mounting points -arrows- on spray jet assembly.
  N92-10099
–  Lever locking lug -arrow- up slightly and pull out spray jet assembly.
Installing:
  Note
The degree to which the cover cap of the spray jet is pulled down onto the bumper cover can be adjusted using the clips on the spray jet assembly. If the spray jet assembly is not pulled in far enough, the cover cap will not seat correctly. If the spray jet assembly is pulled in too far, the cover cap and the bumper cover could be pushed out of shape.
–  Push spray jet assembly into pop-up cylinder until it engages.
–  Fit cover cap on spray jet assembly and allow pop-up cylinder to retract.
–  Check the cover cap is seated correctly on the bumper cover.
–  If necessary, adjust seat of cover cap by pushing spray jet assembly in higher or lower position on pop-up cylinder.
–  On completion of installation work, bleed headlight washer system → Chapter.
–  Check headlight washer system spray jets and adjust if necessary → Chapter.
  N92-10014

Adjusting headlight washer system spray jets > < Removing and installing spray jet pop-up cylinders »Golf R«