volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing spray jet pop-up cylinders »Golf R« > < Removing and installing headlight washer system pumpV11

Golf Mk6

Removing and installing spray jet pop-up cylinders
Removing and installing spray jet pop-up cylinders
  Note
t  Following illustrations show removal and installation of left spray jet pop-up cylinder.
t  Removal and installation of right spray jet pop-up cylinder are carried out in the same way.
Removing:
–  Switch off ignition and all electrical consumers and remove ignition key.
   
–  Pull spray jets together with cover cap -1- out of bumper cover to stop.
–  Unclip cover cap -1- from mounting points -arrows- on spray jet assembly.
–  Remove front bumper cover → General body repairs, exterior; Rep. gr.63.
  N92-10099
–  Push down securing clip -arrow- and pull hose connection away from pop-up cylinder.
  N92-10449
–  Remove securing bolt -1-.
  N92-10450
–  Press both catches together simultaneously in direction of -arrow- and pull pop-up cylinder -2- downwards out of bracket in bumper cover -1-.
Installing:
Install in the reverse order of removal. When doing this, note the following:
–  Tighten all threaded connections to torques specified in assembly overview → Chapter.
–  On completion of installation work, bleed headlight washer system → Chapter.
  N92-10451

Removing and installing spray jet pop-up cylinders »Golf R« > < Removing and installing headlight washer system pumpV11