Golf L4-1.8L Turbo (AWD) (2000)
Sealing Flange, Engine Rear: Service and Repair
Sealing flanges and drive plate, removing and installing
Note: For repairs to the clutch.
1-9O Nm + 1/4 turn (90°) further
^
Always replace
^
Counterhold with 3415 to loosen and tighten
^
Threads and shoulder must be free of oil and grease
2-Crankshaft toothed belt sprocketSee:
3-15 Nm
4-Oil seal
^
Replacing.
5-Sealing flange
^
Must be located on dowel sleeves
^
Clean sealing surface before installing
^
Insert with silicone sealant D 176 404 A2
^
Removing and installing.
^
To remove and install remove oil pan
6-Cylinder block
^
Removing and installing crankshaft.
^
Disassembling and assembling pistons and connecting rods.See:
7-60 Nm + 1/4 turn (90°) further
^
Always replace
8-Flywheel/drive-plate