Golf L4-1.8L Turbo (AWD) (2000)
-
With help of handle -1- guide trimming needle -2- under sealing lip -3- and puncture adhesive bead (use on lower edge of rear window).
NOTE: The trimming needle must be guided as close as possible to the window
-
Unscrew handle and pass cutting thread through eye of needle.
-
Pull cutting thread toward interior (use pliers and gloves).
-
Guide cutting thread in between sealing lip and window flange with help of tube -1- (cutting wire may also be used if thread breaks). If gap is too
small guide cutting thread on outside and push under lip with a plastic wedge.
-
Place cutting thread around rear window as shown.
NOTE: Press in cutting thread deep enough to avoid damaging the sealing lip and/or spacing lip.
-
Pull end of thread in toward interior and secure to pulling handle VAG 1351/1 to counter-hold.
-
Cover inside of window flange -1- with textile reinforced adhesive tape (only when using cutting wire).
-
Secure inner end of thread on winding device.