Golf L4-1.8L Turbo (AWW) (2003)
Tip: Note placement of foam isolator washers at each mounting pin location (may come off with motor).
Tip: New washers are included in kit and must be installed between window regulator and motor on final assembly of motor to regulator.
^
Clean any grease and dirt from tracks and around regulator insertion hole (arrow).
^
Carrier assembly is now ready to install new cables.
Regulator assembly, preparing for installation
^
Remove three foam washers from assembly.
^
Unfold cables, tie wraps (arrows) through center of assembly are removed later in procedure).
Tip: Orientation of tie wraps should be such that the locking block of the tie wrap does not interfere with installation of regulator to the carrier
assembly.
Regulator/cable assembly, installing
Tip: Slide long cable (from regulator) under single cable (already installed).
^
Attach regulator to carrier by inserting three pins from regulator into the carrier assembly (pressing gently to seat).
^
Slide cable sheathing ends into regulator (arrows).