Golf L4-1.8L Turbo (AWW) (2003)
7. Brake master cylinder
-
Can not be repaired. Replace complete if there are malfunctions.
8. Holding plate
-
Used to fasten the wiring harness
9. Hex nut, self-locking 20 Nm
10. Heat shield plate
-
Only on vehicles with 74 kW, 92 Kw, 110 kW, 150 kW engines
-
See Parts supplier
11. Sender -1- for Brake Booster -G201-
-
Removing and installing
12. Sender -2- for Brake Pressure -G214-m
-
Removing and installing
13. Sealing ring
-
Always replace
14. Connecting housing
15. Wiring harness
16. Vacuum hose
-
Install in brake booster
17. Sealing plug
18. Seal
-
for brake booster
19. Hex nut, self-locking, 20 Nm
20. Boot
-
Make sure correct seat, danger of suction noises
Vacuum pump for brake booster, removing and installing (vehicles with Diesel engines)
Removing
-
Remove retainer for wiring harness from vacuum pump.
-
Loosen vacuum hose clamp (arrow -A-) and remove hose from pump.
-
Remove bolts (arrow -B-) on flange.
-
Remove vacuum pump.
Note: The vacuum pump cannot be repaired.
Installing
Note: When installing the vacuum pump be sure that the follower engages correctly with the camshaft.