Golf L4-1.8L Turbo (AWW) (2003)
-
Pivot the lock carrier -3- with radiator in the forward direction -arrow-
-
Attach latch tool T10253 -2- between lock carrier -3- and mounting panel for headlight -1- on both left and right sides using bolts -4-
NOTE: Each holding tool is marked "R" for right side or "L" for left side
-
Disconnect connectors -arrows- from all ignition coils
NOTE: Only ignition coils that are not one of the production levels shown on Page 2 "Parts Information" must be replaced
-
Using Puller T10095, remove ignition coils
CAUTION: USE OF TOOL T10095 IS REQUIRED TO AVOID DAMAGING THESE SENSITIVE COMPONENTS
-
Install new ignition coils (022 905 100C/F/J) by pressing into cylinder head by hand only
IMPORTANT:
-
Do not use any object to tap ignition coil into position
-
Do not twist ignition coil when installing
-
Reconnect connectors to ignition coils
-
Remove latch tool T10253
-
Pivot the lock carrier with radiator back into position
-
Secure lock carrier with bolts -1- on left and right sides and tighten to 10 Nm (7 ft. lbs.)
-
Reinstall engine cover and secure with T30 Torx® screws
-
If the MIL light was on and cylinder misfire DTCs were present, printed and erased, use VAS5051 and set engine readiness code
-
Attach a copy of print out for diagnostic log (showing cylinder misfire DTCs) and readiness code "Test Complete" to repair order
NOTE: Readiness code setting is not related to this action when other components related to the MIL light are diagnosed and repaired
-
Destroy and properly dispose of removed ignition coils