Golf L4-1.8L Turbo (AWW) (2003)
-
Place cable over cam on pulley as shown.
-
Grab both clamps and slide to bottom of assembly (cable will self-install into pulley groove).
-
Use correct tool (as necessary) if cable will not self-install.
After installing cable on pulley:
-
Remove tie wraps from regulator.
-
Install three foam washers on mounting pins on motor side of carrier.
-
Carefully install motor assembly while holding cable housing assembly against the carrier.
Tip:
Failure to hold cable housing assembly against carrier may allow housing to fall away from carrier, which may cause housing pulley to come apart.
^
Remove metal clamp or locking pliers.
^
Temporarily connect power and window switch to motor assembly and cycle regulator several times.
^
Lubricate guides and track along full length, on top, and underside of track (white arrows) on contact surfaces with lubricant Part No: 00045002.
^
Cycle regulator again (several times) to verify proper function.
Prior to removing power:
^
Move clamps into the proper window installation position (so fasteners can be tightened once window is installed).
^
Carefully install carrier into door and reinstall window regulator motor onto carrier assembly, see Repair Manual Group 64 in Elsaweb.
Mating Glass to Window Regulator Clamps