Golf L4-1.9L DSL Turbo (ALH) (1999)
14. Bolt, 25 Nm (18 ft. lbs.)
-
For support bracket -11 -
15. Boot
-
Carefully pull over gear selector cable end piece
-
Use MOS2 grease
16. Relay lever
-
Remove before removing clutch control
-
Installation position.
-
Servicing.
17. Self-locking nut, 15 Nm (11 ft. lbs.)
-
For relay lever to actuating arm
-
Only loosen to adjust selector mechanism
18. Actuating arm
-
With pivot pin to mount relay lever
-
Installation position.
-
Servicing.
19. Rubber bushing
-
For gate selector cable to actuating arm
-
Press in and out with drift
20. Bolt, 25 Nm (18 ft. lbs.)
-
For balance weight
21. Balance weight
-
Remove to adjust selector mechanism
22. Self-locking nut, 15 Nm (11 ft. lbs.)
-
For selector cable to selector housing
23. Rubber washer
24. Rubber bushing
-
For gear selector cable/gear change lever
-
Press in and out with drift
25. Rubber bushing
-
For gate selector cable/selector bracket
-
Press in and out with drift