Golf L4-1.9L DSL Turbo (BEW) (2004)
Trunk / Liftgate Lock: Diagrams
Rear Lid Lock, Removing And Installing
1. Lock cylinder housing
2. Handle
-
Remove bolt Item -4-, disconnect connector for switch Item -3- and remove handle from lid.
3. Tailgate/trunk lid release switch E165
4. Bolt
-
7 Nm
5. Carrier plate
6. Operating rod
-
Press actuator lever with linkage clip Item -13- against stop and engage operating rod free of tension
7. Nut
-
7 Nm
8. Tailgate/trunk lid release motor V139
-
Removing
-
Disconnect connector from motor.
-
Unclip operating rod, See Item -6- from lock cylinder housing.
-
Unclip operating rod Item -9- from motor for rear lid release.
-
Unclip operating rod Item -9- from motor for rear lid release.
-
Remove hex nuts Item -7- and remove carrier plate Item -5-.
-
Remove motor for rear lid release Item -8- from carrier plate.
9. Operating rod
-
Press actuator lever with operating rod Item -13- against stop and engage operating rod free of tension
10. Bolt
-
22 Nm
11. Lock
-
Removing
-
Remove lid trim
-
Disconnect connector from lock.