Golf L4-1.9L DSL Turbo (BEW) (2004)
-
Use special clic-hose clip pliers V.A.G 1723 to remove clamp and vacuum hose -1- from tandem pump -4-
-
Remove clamp and fuel supply hose -2- with white mark from tandem pump
-
Remove 6mm socket head bolts -arrow A- and 5mm socket head bolts -arrow B- securing tandem pump to cylinder head
-
Separate tandem pump from cylinder head
-
Raise tandem pump slightly upward, remove clamp and fuel return hose -3- with blue mark and remove tandem pump
-
Remove seal if it was not removed with tandem pump
-
Clean rear surface of cylinder head in preparation for new tandem pump installation
-
Proceed to Section C
Section C
Section C - Golf and Jetta Tandem Pump Installation
-
On new tandem pump (038 145 209 E) connect fuel return hose -3- with blue mark to return connection of tandem pump -4- and secure with
spring clamp
-
Ensure coupling is properly aligned to camshaft, install tandem pump and secure with socket head bolts -arrow A- and -arrow B-
-
Tighten upper 6mm socket head bolts -arrow A- to 20 Nm (15 ft. lbs.) and lower 5mm socket head bolts -arrow B- to10 Nm (7 ft. lbs.)
-
Connect fuel supply hose -2- with white mark to fuel supply connection of tandem pump and secure with spring clamp
-
Connect vacuum hose -1- to tandem pump and secure with clamp