Golf L4-1.9L DSL Turbo (BEW) (2004)
-
Remove selector lever cable -1- from retainer-arrow- on engine.
-
Raise vehicle.
-
Unbolt retainer from catalyst on subframe and pull to rear. Loosen double clip.
Do not remove catalyst. Leave on subframe.
-
Remove selector lever from retainer on front heat shield.
-
Remove front tunnel heat shield.
-
Loosen center tunnel heat shield and slide to rear.
-
Unscrew 4 nuts -arrows A-.
-
Unscrew two bolts -arrows B-.
-
Carefully slide cover with protective sleeve to front over selector lever cable.
Note: Be careful not to damage protective sleeve.
-
Pry selector lever cable -3- off selector lever -2- with a screwdriver.
-
Pull out selector lever cable locking plate -1- on mounting bracket downward.
-
Pull selector lever cable carefully out of mounting bracket.
-
Remove selector mechanism completely out of tunnel.
Installing
-
Check the protective sleeve for damage; the protective sleeve can only be changed together with the selector lever cable.
-
Check that the protective sleeve is correctly tiffed. Do not install protective sleeve twisted.
-
Do not bend or kink the selector lever cable.
-
Selector lever and lever/selector shaft are in "P" position, the front wheels are blocked.