Golf L4-1.9L DSL Turbo (BEW) (2004)
With both window clamps installed on tracks:
^
Check the four plastic cable guide ends (black arrows) for correct engagement into housing.
With both clamps at the middle of carrier assembly as shown (white arrows):
^
Install cable on last pulley, see "Cable, installing on pulley (notched pulleys)".
Cable, installing on pulley (notched pulleys)
Install cable on last pulley as follows:
^
Place cable over pulley.
^
Insert correct installation tool pin (Tool #3 or #4) into pulley notch (white paint mark on side of tool indicates correct pin).
With remaining pins of tool engaged into face of pulley:
^
Rotate tool and pulley 360 degrees until cable is wrapped around pulley.
Tip:
It may be necessary to rotate pulley an additional 360 degrees to set cable into pulley groove.
Cable, installing on pulley (cam faced pulleys)
-
Place cable over cam on pulley as shown.
-
Grab both clamps and slide to bottom of assembly (cable will self-install into pulley groove).
-
Use correct tool (as necessary) if cable will not self-install.