Golf L4-1588cc 1.6L DSL SOHC (1987)
^
clean oil/grease residue from threads using approved nitro thinners, or L160, or equivalents
^
clean threads with compressed air
Installing
^
check/adjust left tie rod length
^
a = 379.5 mm (14-15/16 in.)
^
apply locking compound (D6 or equivalent), to threaded hole (arrow)
^
apply only one drop locking compound in second thread of rack
^
excessive compound will make subsequent removal difficult
CAUTION
Avoid getting locking compound on toothed rack.
^
tighten tie rod
^
specified torque = 70 N-m (52 ft.lb): always verify with a torque wrench
^
examine boot for wear (slits, cracks) and check sealing surface for cleanliness
^
install boot
^
turn tie rod ball joint stud to installation position
^
connect pressure compensating line
^
ensure correct seating
