Golf L4-2.0L (AEG) (1999)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor on Rear Axle
ABS System Components On Rear Axle, Removing And Installing
1. All wheel speed sensor Before inserting sensor, clean mounting hole inner surface and coat with lubricant G 000 650
2. Hex socket head bolt, 8 Nm (70 inch lbs.)
3. Stub axle
4. Splash shield
5. Wheel hub with wheel bearing and speed sensor rotor
^
Replace each time after disassembly
^
Only replace complete
^
Removing and installing refer to Transmission and Drivetrain; Drive Axles, Bearings and Joints.
6. Self-locking 12-point nut, 175 Nm (129 ft. lbs.). Replace each time after removing
7. Cap
^
Pressing off and driving in.
8. Brake disc
9. Screw
10. Hex bolt, 60 Nm (44 ft. lbs.)
^
With dished spring
11. Axle beam
Wheel Speed Sensor On Rear Axle, Removing And Installing
Removing
-
Raise vehicle.
-
Disconnect wheel speed sensor and speed sensor wiring connector -1-.
-
Remove bolt -2- from stub axle.
-
Pull ABS wheel speed sensor out of stub axle.
Installing
-
Before inserting wheel speed sensor, clean mounting hole inner surface and coat speed sensor with lubricant G 000 650.
-
Insert wheel speed sensor into hole in stub axle and tighten bolt to 8 Nm (70 inch lbs.).
-
Connect wheel speed sensor to speed sensor wiring.