Golf L4-2.0L (AEG) (1999)
/Page-618001.png)
Oil Filter Adapter: Diagrams
Oil filter flange assembly
1. Sealing plug, 40 Nm (30 ft. lbs.)
2. Seal
^
Always replace
3. Spring for pressure relief valve, approximately 4 bar (58 psi)
4. Piston for pressure relief valve
5. Gasket
^
Always replace
6. Check valve, 8 Nm (21 ft. lbs.)
7. Seal
^
Install onto sealing cap shoulder (item 8)
8. Sealing cap
9. Retaining clip
^
Check for seating
10. Sealing plug, 15 Nm (11 ft. lbs.)
^
Cut off seal and replace if leaking
11. 1.4 bar oil pressure switch F1, 25 Nm (18 ft. lbs.)
^
Black
^
Checking
12. Oil filter flange
^
With 4 bar (58 psi) relief valve
13. 15 Nm (11 ft. lbs.) + 1/4 turn (90°)
^
Always replace
^
Measure torque angle with torque angle wrench, i.e. Hazet 6690
14. Seal
^
Always replace
^
Fit into groove on oil cooler
15. Oil cooler
^
Coat mounting surface of oil filter flange outside seal with sealant AMV 188 100 02
^
Allow room for surrounding objects
16. 25 Nm (18 ft. lbs.)
17. Oil filter
^
Loosen with strap wrench
^
Hand tighten
^
Observe installation instructions on oil filter
