Golf L4-2.0L (AEG) (1999)
If oxygen sensor heater has continuity
Checking voltage supply
-
Set multimeter to "Voltage measurement" range.
-
Connect multimeter using aux. cables from VW1594 to measure voltage at terminals 1 and 2 (harness connector to Engine Control Module
(ECM).
-
Start engine and run at idle
-
Measure voltage supply and observe display group 41, display field 4.
Display: Htg.aC.ON
-
Specified value: 11.0-14.5 V
Display: Htg.aC.ON/Htg.aC.OFF (alternating)
-
Specified value: Between 0.0-12.0 V fluctuating
-
Turn off ignition.
If no voltage is present:
-
Remove wiper arms and plenum chamber cover.
-
Connect VAG1598/22 test box to control module wiring harness.