Golf L4-2.0L (AZG) (2004)
Fig. 1 Checking installation position of double clamp
-
Position double clamp with approximately 5 mm clearance to the appropriate marking.
^
Marking A (arrow -1-) for models with an automatic transmission.
^
Marking S (arrow -2-) for models with an manual transmission.
Fig. 2 Installation position of mounting
Angled side on base of mounting (arrow) points forward.
Fig. 3 Separating point on exhaust pipe
-
Separate exhaust pipe at right angles at separating point (arrow -2-).
-
Position repair double clamp -4- on side markings (arrows -1- and -3-) to install.
Tightening torque: 40 Nm
Fig. 4 Aligning front muffler free of stress
The mounting pins on the front muffler must run parallel with the tunnel bridge (dimension -x- on left and right the same).